Kloubová oka Fluro

39 FLURO ® -Gelenklager GmbH 4 1) 7 5,25 14 30 37 6,5 M 4 19 2,5 5,1 14 9 5 8 6,00 18 33 42 7,7 M 5 19 6,2 7,5 600 13 13 6 9 6,75 20 36 46 8,9 M 6 21 8,8 9,3 530 13 20 8 12 9,00 24 42 54 10,4 M 8 25 16,1 16,7 420 14 33 10 14 10,50 28 48 62 12,9 M 10 28 25,5 23,4 350 13 56 12 16 12,00 32 54 70 15,4 M 12 32 34,5 32,0 300 13 87 14 19 13,50 36 60 78 16,8 M 14 38 39,5 42,0 260 16 129 16 21 15,00 42 66 87 19,3 M 16 40 60,5 52,5 230 15 189 18 23 16,50 46 72 95 21,8 M 18x1,5 44 73,0 64,0 210 15 267 20 25 18,00 50 78 103 24,3 M 20x1,5 47 83,0 78,0 190 14 348 22 28 20,00 54 84 111 25,8 M 22x1,5 51 100,0 97,0 170 15 443 25 31 22,00 60 94 124 29,6 M 24x2 57 118,0 122,0 150 15 600 30 37 25,00 70 110 145 34,8 M 30x2 71 155,0 168,0 130 17 1030 35 43 28,00 80 125 165 37,7 M 36x2 73 191,0 206,0 110 19 1600 40 49 35,00 90 142 187 44,2 M 42x2 78 235,0 286,0 100 16 2570 B M A F l o G Gl ! Size (D H7) Rod Ends Series K - Stainless, Maintenance Free Series GARSW Rod End with male thread and PTFE liner For use at high dynamic pressure and tension loads in corrosive environments Static load C o kN Dynamic load C kN limiting speed rev/min Weight g Materials: Housing: Stainless steel to 1.4057, Aisi 431, forged, polished size 40 turned from stainless steel to 1.4057, Aisi 431 insert: Special high strength bronze to CuSn8 with PTFE liner bonded to the inner surface Ball: Bearing steel to 100Cr6, Aisi 52100, hardened, ground, polished, hard chrome plated on the running surface This series is also available sealed (see page 52) or with threaded bolt (see page 53). 1) Size 4 on request. Housing turned from stainless steel to 1.4305, Aisi 303 / 1.4301, Aisi 304 only for short-term revolutions recommended Please note: The dynamic load "C" of the bearing of some rod ends is in some sizes higher than the static load "C o " of the rod end. Maximum Pivoting Angle (°)