Kloubová oka Fluro

41 FLURO ® -Gelenklager GmbH 4 1) 7 5,25 14 30 37 6,5 M 4 19 2,5 5,1 14 9 5 8 6,00 18 33 42 7,7 M 5 19 6,2 7,5 600 13 13 6 9 6,75 20 36 46 8,9 M 6 21 8,8 9,3 530 13 20 8 12 9,00 24 42 54 10,4 M 8 25 16,1 16,7 420 14 33 10 14 10,50 28 48 62 12,9 M 10 28 25,5 23,4 350 13 56 12 16 12,00 32 54 70 15,4 M 12 32 34,5 32,0 300 13 87 14 19 13,50 36 60 78 16,8 M 14 38 39,5 42,0 260 16 129 16 21 15,00 42 66 87 19,3 M 16 40 60,5 52,5 230 15 189 18 23 16,50 46 72 95 21,8 M 18x1,5 44 73,0 64,0 210 15 267 20 25 18,00 50 78 103 24,3 M 20x1,5 47 83,0 78,0 190 14 348 22 28 20,00 54 84 111 25,8 M 22x1,5 51 100,0 97,0 170 15 443 25 31 22,00 60 94 124 29,6 M 24x2 57 118,0 122,0 150 15 600 30 37 25,00 70 110 145 34,8 M 30x2 71 155,0 168,0 130 17 1030 35 43 28,00 80 125 165 37,7 M 36x2 73 191,0 206,0 110 19 1600 40 49 35,00 90 142 187 44,2 M 42x2 78 235,0 286,0 100 16 2570 B M A F l o G Gl ! Size (D H7) Rod Ends Series K - Stainless, Maintenance Free Series GARSW..R Rod End with male thread and PTFE liner For use at high dynamic pressure and tension loads in corrosive environments Materials: Housing: Stainless steel to 1.4057, Aisi 431, forged, polished size 40 turned from stainless steel to 1.4057, Aisi 431 insert: Special high strength bronze to CuSn8 with PTFE liner bonded to the inner surface Ball: Stainless steel 1.4034, hardened, ground, polished This series is also available sealed (see page 52) or with threaded bolt (see page 53). 1) Size 4 on request. Housing turned from stainless steel to 1.4305, Aisi 303 / 1.4301, Aisi 304 Please note: The dynamic load "C" of the bearing of some rod ends is in some sizes higher than the static load "C o " of the rod end. Static load C o kN Dynamic load C kN limiting speed rev/min Maximum Pivoting Angle (°) only for short-term revolutions recommended Weight g