Stavebnicový systém MB 9 - EN

208 6 20 40 10 5.4 Sliding-Door Guide Profile 8 40x10 Al, anodized A [cm 2 ] m [kg/m] 2.48 0.67 natural, cut-off max. 3000 mm 0.0.495.13 natural, 1 pce., length 3000 mm 0.0.495.12 12.4 23.8 2 Roller for Corner-Fastener 8 32x18 Roller insert Compression spring Llimit stop Cap, PP grey Notes on Use and Installation m = 10.5 g 1 set 0.0.494.74 Spring-loaded Roller Set 32x18 is fitted into the corner fasteners of the previously constructed clamp profile frames. A Roller Set must be installed in each fastener so as to guide the sliding door leaf. A limit stop can be installed to prevent the roller insert from springing. The corner fasten- ers at the bottom of a sliding door frame are always installed with rigid rollers. Spring- loaded rollers in the corner fasteners at the top enable the door leaves to be fitted into a profile frame which has already been built. If required, all four roller inserts may be blocked by limit stop inserts and the outer pro- file frame finished after the sliding door leaves have been fitted. This effectively prevents the doors from being removed without disman- tling the frame. After the rollers have been fitted, a plastic end cap closes the fastener at the side and serves as a door stop in the terminal positions. Sliding-Door Guide Profile 8 40x10 is fitted with Clip 8 St at the top and bottom of the surrounding profile frame. It forms the guide for two door leaves of Clamp Profile 8 32x18. The sliding doors can also be run directly in the grooves of a Line 5 profile. This pro- duces a particularly compact frame construction. E N C L O S U R E S , G U A R D S A N D P A R T I T I O N S