Stavebnicový systém MB 9 - EN

89 XXX JUFN DPN ḏ *OOPWBUJPO 2 19.5 Ø12 Ø20 5 Automatic-Fastening Set 8 N Automatic Fastener 8 N, St, black Cap, PA grey Hexagon Socket Head Cap Screw M6x30, St, bright zinc-plated T-Slot Nut V 8 St M6, bright zinc-plated M = 14 Nm m = 27.0 g bright zinc-plated, 1 set 0.0.489.96 19.5 Ø12 Ø20 5 Automatic-Fastening Set 8 N Automatic Fastener 8 N, St, stainless Cap, PA grey Hexagon Socket Head Cap Screw M6x30, St, stainless T-Slot Nut 8 St M6, stainless M = 11 Nm m = 29.0 g stainless, 1 set 0.0.669.05 673 The fastener is located inside the profile cavity. To access the fastening screw just drill a hole into the profile. The grey Cap is used to close the hole. A T-Slot Nut is inserted into the groove in the second profile and forms the counterpart for the Automatic Fastener screw. If this groove in the second profile is also closed, the T-Slot Nut must be inserted from either the profile’s end face or through a larger opening in the groove cover created beforehand. Automatic-Fastening Sets should always be used in pairs. Opening the closed groove of a Line 8 Profile in order to insert the T-Slot Nuts of two Automatic-Fastening Sets 8 N. s = 6 A/F ■ ■ For rectangular profiles with closed grooves ■ ■ Surfaces stay easy to clean Note: A special 5 A/F N L-Key is available for tightening the screw connection of Automatic- Fastening Sets 8 N. Automatic-Fastening Set 8 N Special form of the Automatic-Fastening Set for installation in profiles with closed grooves. The groove is opened as shown below. F A S T E N I N G T E C H N O L O G Y