Stavebnicový systém MB 9 - EN

91 c b a f e d 2 Central-Fastening Set a b c d e f 8 20 mm ⌀ 7 mm ⌀ 8.2 mm 26.7 mm ⌀ 14.2 mm 12/11 mm* 10 25 mm ⌀ 9 mm ⌀ 10.5 mm 34 mm ⌀ 18.2 mm 15 mm Ø14 28 □15 Central-Fastening Set 8 Clamping pin, St, bright zinc-plated Clamping spring, St, stainless Sleeve with bore, St, bright zinc-plated Grub screw M10, St, bright zinc-plated Cap, PA grey M = 15 Nm m = 42.0 g 1 set 0.0.494.15 35.8 ⌀18 19.5 Central-Fastening Set 10 Clamping pin, St, bright zinc-plated Spring element, St, stainless Sleeve with bore, St, bright zinc-plated Grub screw M12, St, bright zinc-plated M = 22 Nm m = 87.0 g bright zinc-plated, 1 set 0.0.632.74 Due to the reduced clamping force and the lack of any anti- torsion feature between the profiles, this fastening set should only be used in combination with panel elements in the profile groove and only for profile connections subject to low loads. Where more stringent requirements need to be satisfied and parts are important for safety considerations, it is advisable to use the proven fastening techniques for basic construc- tions (Standard-Fastening, Universal-Fastening or Automatic- Fastening Sets). The profile to be connected via its end face needs to be machined before the Central- Fastening Set can be used. The hole to accommodate Central-Fastening Set 8 should be produced with Step Drill D14.2 (0.0.492.60). The hole to accommodate Central-Fastening Set 10 should be produced with Step Drill D18.2 (0.0.632.75). Central-Fastening Sets The Central-Fastening Set connects profiles at right angles to each other and leaves the grooves that are facing each other completely free. This is useful when the profile ■ ■ For building frames for panel elements ■ ■ Flexible connection with a stand profile ■ ■ Medium resistance to displacement F A S T E N I N G T E C H N O L O G Y grooves are to accommodate a panel element. It eliminates the need to specially machine the corner areas of the panel element, which instead can be inserted directly into the grooves. * When using Radius Seals in combination with Central-Fastening Set 8, the distance between the hole and the end face of the profile should be reduced from 12 mm to 11 mm.