Stavebnicový systém MB 9 - EN

130 Ø8.2 Ø14.2 Ø14.2 Ø7 26.7 Ø8.2 20 2 28 Ø14 Central-Fastening Set P 8 Clamping pin, St, bright zinc-plated T-Slot Nut V 8 St M8, bright zinc-plated Threaded sleeve with bore, St, bright zinc-plated Grub screw M10, St, bright zinc-plated Cap, PA, grey m = 44.0 g 1 set 0.0.619.69 Drilling Jig and Step Drill, Mitre Connection 657 Profile processing: To accommodate the fastener sleeve, a ⌀14.2 mm counterbore is drilled into the side of one of the profiles being connected (using Step Drill 0.0.492.60) along with a ⌀8.2 mm fastening hole located perpendicular to this. T-Slot Nut V 8 St M8 is fitted into the facing groove of the second profile and the clamping pin is screwed into this T-Slot Nut as far as the marking. After the clamping pin has been inserted into the fastener sleeve, the profile connection is tightened with an M10 grub screw (tightening torque M = 15 Nm). N.B.: At least 2 grooves always remain free for fitting panel elements into the pro- file grooves. Frame elements can also be connected to each other at an angle of 90° by positioning Central-Fasten- ing Set P 8 appropriately. ■ ■ Connect two parallel Profiles 8 ■ ■ Flush connection for partitioning and room dividers Central-Fastening Set P 8 Central-Fastening Set P 8 can be used to quickly connect together individual, inherently stable partitions or partition elements side by side without time-consuming alignment procedures. F A S T E N I N G T E C H N O L O G Y Unevenness in the ground can be compensated for by adjust- ing the position of the T-Slot Nut in the profile groove.