Stavebnicový systém MB 9 - EN

415 XXX JUFN DPN 12 M6 M8 DIN933 M8x30 DIN7984 M8x16 DIN ISO14 6x11x14 50 80 40 17 Chain Reverse Unit 8 80 VK14 Chain Reverse Unit, die-cast zinc, black, pre-assembled Ball-bearing sprocket wheel, z = 16 (z = number of teeth) One revolution corresponds to 203.2 mm effective radius r w = 32.3 mm Hub with multi-spline DIN ISO 14-6x11x14 Hub depth 30 mm, Max. load: M D = 20 Nm Tensioning Block, die-cast zinc, black, pre-assembled Fastening screws, St, black, 2 caps, PA, black Chain length in Reverse Unit 236.3 mm Notes on Use and Installation m = 1.1 kg 1 pce. 0.0.463.37 ⌀8 50 M6 M8 DIN933 M8x30 17 DIN7984 M8x16 80 40 Chain Reverse Unit 8 80 with Bore Chain Reverse Unit, die-cast zinc, black, pre-assembled Ball-bearing sprocket wheel, z = 16 (z = number of teeth) One revolution corresponds to 203.2 mm effective radius r w = 32.3 mm Hub with bore D8, reborable up to max. ⌀ 15 mm Hub depth 30 mm, Max. load: M D = 20 Nm Tensioning Block, die-cast zinc, black, pre-assembled Fastening screws, St, black, 2 caps, PA, black Chain length in Reverse Unit 236.3 mm Notes on Use and Installation m = 1.1 kg 1 pce. 0.0.463.75 Couplings 623 The Chain Reverse Unit incorporates integrated chain tension- ing block and clamp. The Chain tensioning distance is 2x13 mm in total. The Chain tension must be set so that the Chain can also be operated with the slack side of the Chain only slightly pre-tensioned. The Chain can be driven directly using the Chain Reverse Units or the Chain Counter- Reverse Unit. The sprocket wheels of the Chain Reverse Units are available with multi- spline hub VK14 or with a bore that can be machined as required. Use of multi-spline hub VK14 enables the modular accessories (Synchroniser Shafts) to be used without any restrictions. Chain Reverse Units 8 80 ■ ■ Combination of Reverse Unit and Tensioning Block ■ ■ Can be connected directly to a motor ■ ■ Safe, concealed chain It is possible to fit motors and couplings D55 directly to the Chain Reverse Unit. C O N V E Y O R S