Stavebnicový systém MB 9 - EN

564 l 4.4 40 15 9.8 ⌀11 ⌀16 4.4 ⌀5.5 M8 L □40 3 4.1 ⌀12 H8 M8 36 36 8.4 4 M6 4 15 21 10 8 11.2 Adjuster Profile 8 Al m = 592.0 g/m natural, cut-off max. 6000 mm 0.0.657.21 natural, 1 pce., length 6000 mm 0.0.657.20 The length of the slide (L) determines how long the Adjuster Profile (l) needs to be. l = L - 12.4 mm Machining requirements when using Slide Profiles LRF 8 in customised lengths. The indentations at the side offer a good point of orientation. The Slide Profiles allow users to locate mounting bores at will. The positioning collars can be used as necessary. Adjuster Profile 8 Slide Profiles LRF 8 Adjuster Profile 8 ensures there is no play between the roller units and shaft, even on long slides. The bearing units of Slide Sets LRF 8 don’t exhibit displacement over long-term use either. Consequently, Slide Profile LRF 8 runs with very little wear, even in the case of very long slides. Slide Sets LRF 8 are fastened to the Adjuster Profile via a screw connection. The Profile is inserted into the special groove and runs the entire length of the slide. Note : The Adjuster Profile needs to be machined before the Slide Set can be installed. Your item partner can do this as an additional service. ■ ■ Optimum hold, even on long carriages ■ ■ Connects together Slide Profile and Slide Sets LRF 8 The surface of Slide Profile LRF 8 is flat and face-milled. The underside of the Slide Profile features a Line 8 groove as well as special grooves to accommodate Adjuster Profile 8, to which the Slide Set LRF 8 is fastened. Two threaded bores need to be machined to enable adjustment of the rollers. One of the special grooves for the Adjuster Profile is wider than the other in order that the rollers can be adjusted via a grub screw so as to eliminate play. Note: Please note the tightening torques recommended in the installation guide. ■ ■ For building strong custom carriages ■ ■ Available in four widths ■ ■ Up to 3000 mm in length  L I N E A R S L I D E S