Stavebnicový systém MB 9 - EN

631 16 Synchronizer Shaft Equaliser Coupling VK14 VK32 L 80 mm 120 mm a 1-1.5 mm 2-3 mm b min. 40 mm min. 60 mm ⌀14 ⌀44 80 Synchroniser Shaft Equaliser Coupling VK14 2 half shells, St, bright zinc-plated 8 Hexagon Socket Head Cap Screws DIN 912-M8x20, St, bright zinc-plated and waxed m = 0.7 kg 1 set 0.0.472.28 ⌀32 ⌀72 120 Synchroniser Shaft Equaliser Coupling VK32 2 half shells, St, bright zinc-plated 8 Hexagon Socket Head Cap Screws DIN 912 M10x30, St, bright zinc-plated and waxed 8 screws M6x25, St, bright zinc-plated m = 2.8 kg 1 set 0.0.472.29 6.2 ⌀72 DIN ISO14 6x26x32 Synchronising Shaft Profile VK32 Al, anodized A [cm 2 ] m [kg/m] I x [cm 4 ] I y [cm 4 ] I t [cm 4 ] 11.62 3.13 47.42 45.09 65.95 natural, cut-off max. 3000 mm 0.0.463.56 natural, 1 pce., length 3000 mm 0.0.454.05 Clamping Set for Synchronising Shaft Profile VK32 8 standard connecting plates 6, St, bright zinc-plated 4 T-Slot Nuts 8 St 2xM6-60, bright zinc-plated 8 screws M6x25, St, bright zinc-plated m = 196.0 g 1 set 0.0.463.30 The Synchroniser Shaft Equaliser Coupling is positioned at the ends of the Multi-Spline Shafts and power-lock connected using clamping screws. The tightening torque of the clamping screws is 25 Nm (Equaliser Coupling VK14) or 50 Nm (Equaliser Coupling VK32). The two halves of the coupling must be screwed onto degreased shaft ends using the waxed screws supplied, so as to transfer the necessary torque. Synchroniser Shaft Equaliser Couplings ■ ■ For the precise angular alignment of synchronised linear drives ■ ■ Power-lock connection for Multi-Spline Shafts M E C H A N I C A L D R I V E E L E M E N T S