Stavebnicový systém MB 9 - EN

118 XXX JUFN DPN 4FSWJDF 30°< γ <90° 90° Ød 1 Ød 2 t 1 t 2 2 d 1 t 1 d 2 t 2 M [Nm] ⌀9.1 21 ⌀5.5 15 3.5 Drill 0.0.628.25 0.0.628.55 Drilling Jig 0.0.616.77 0.0.616.89 ⌀14.2 26.7 ⌀9 12 15 Drill 0.0.492.60 - Drilling Jig 0.0.493.72 0.0.493.71 Ø14 28 Mitre-Fastening Set 8 Clamping pin M8x28.5, St, bright zinc-plated Sleeve with bore, St, bright zinc-plated Grub screw M10, St, bright zinc-plated T-Slot Nut V 8 St M8, bright zinc-plated Cap, PA grey m = 40.0 g 1 set 0.0.492.30 Drilling Jig and Step Drill, Mitre Connection 657 Using the Mitre-Fastening Set: 1. Mitre-cut profile at angle γ. 2. Drill a counterbore (⌀ d 1 ) for the fastener sleeve into the side of the mitre-cut profile. 3. Drill a hole (⌀ d 2 ) into the mitred face of the profile 4. Insert the T-Slot Nut into the profile groove of the continuous profile and screw in the clamping pin until the mark around the perimeter is level with the profile surface. 5. Insert the fastener sleeve into the coun- terbore of the mitred profile and fit the assembly over the clamping pin. 6. Drive the grub screw into the fastener sleeve and clamp the profile connection. 7. Fit the cap onto the fastener sleeve (Line 8). Note: Despite the optimised design, the flow of forces across the inclined contact faces of the profiles is such that only part of the pretension of the screw connection is utilized. Mitre connections therefore have a lower load bearing capacity than other, right-angled profile connections (Standard-Fastening, Universal-Fastening or Automatic-Fastening Set). Mitre-Fastening Sets should therefore not be used for constructing basic frames and safety-related parts that are subject to high loads. Mitre-Fastening Sets ■ ■ Profile connection at any angle from 30° to 90° ■ ■ The profile groove stays free to accommodate panel elements  Your item dealer can provide the required mitre cuts and profile processing as a service. 20.8 Ø9 Mitre-Fastening Set 6 Clamping pin M5x23, St, bright zinc-plated Sleeve with bore, St, bright zinc-plated Grub screw M6, St, bright zinc-plated T-Slot Nut 6 St M5, bright zinc-plated m = 17.0 g 1 set 0.0.627.12 F A S T E N I N G T E C H N O L O G Y