Stavebnicový systém MB 9 - EN

125 2 Automatic Butt-Fastening Set 5 6 8 12 s 1 4 A/F 5 A/F 6 A/F 8 A/F Øc b a Automatic Butt-Fastening Set 5 a [mm] b [mm] c [mm] M bz-p [Nm] m [g] 3 24 7 2.5 11.0 bright zinc-plated, 1 set 0.0.464.19 Automatic Butt-Fastening Set 5 a [mm] b [mm] c [mm] M stainl. [Nm] m [g] 3 24 7 2.5 11.0 stainless, 1 set 0.0.464.18 The following applies to all the sets below: Automatic Fastener with through bore, St Automatic Fastener with threaded bore, St Hex. Socket Head Cap Screw, St Automatic-Fastening Set 5 should be inserted so that the flattening on the thread is flush with the outer edge of the profile. The Fastener is screwed into a profile groove in the end face, the thread being cut automatically. Use of a lubricant is recom- mended. Note: All Fasteners with a through bore for the fastening screw have a counter-clockwise thread on the outside in order to prevent the Fastener twisting when the screw is tightened. The Fasteners with internal threads have a clockwise thread on the outside. When driving the Fastener with internal thread into a profile, additional anti-torsion protection can be provided by leaving the end protruding out so that it projects into the groove opposite. The Fastener with through bore will then need to be driven far enough into the adjoining profile to accommodate it. Automatic Butt-Fastening Sets ■ ■ Connect identical profiles via their end faces ■ ■ No profile machining required The Automatic Butt-Fastening Sets can be used to connect the end faces of two profiles from the same Line without mechani- cal processing. Automatic Butt-Fastening Sets should always be used in pairs. Depending on the profile size and load, several pairs may be necessary. F A S T E N I N G T E C H N O L O G Y