Stavebnicový systém MB 9 - EN

550 XXX JUFN DPN ḏ *OOPWBUJPO 4FSWJDF M6x16 Ø15 4.1 15 ⌀6 9 4 5 11 5 Shaft-Clamp Profile 5 D6 Al, anodized A [cm 2 ] m [kg/m] 0.38 0.10 natural, cut-off max. 3000 mm 0.0.390.02 natural, 1 pce., length 3000 mm 0.0.448.23 1 11 ⌀6 12 0.2 8 Shaft-Clamp Profile 8 D6 Al, anodized A [cm 2 ] m [kg/m] 0.46 0.12 natural, cut-off max. 3000 mm 0.0.356.02 natural, 1 pce., length 3000 mm 0.0.453.67 ⌀10 13 5 8 6.5 18.2 Shaft-Clamp Profile 8 D10 Al, anodized A [cm 2 ] m [kg/m] 0.81 0.22 natural, cut-off max. 3000 mm 0.0.442.03 natural, 1 pce., length 3000 mm 0.0.452.23 ⌀14 18 10.3 8 8 22 Shaft-Clamp Profile 8 D14 Al, anodized A [cm 2 ] m [kg/m] 1.36 0.36 natural, cut-off max. 3000 mm 0.0.294.34 natural, 1 pce., length 3000 mm 0.0.453.68 ⌀25 33 18 8 24.5 20.5 Shaft-Clamp Profile 8 D25 Al, anodized A [cm 2 ] m [kg/m] 3.74 1.01 natural, cut-off max. 3000 mm 0.0.350.02 natural, 1 pce., length 3000 mm 0.0.453.69 Shafts 588 Shaft-Clamp Profile 8 D25 must be fixed to the profile groove with the appropriate number of Countersunk Screws DIN 7991 - M6x16 and T-Slot Nuts 8 M6. The Shaft-Clamp Profiles D25 are provided with mounting holes (200 mm apart). Shaft-Clamp Profiles For using standard profiles as a basis for linear slides These profiles connect Shafts D6, D10, D14 and D25 with the profile grooves of the corresponding lines. First the Shaft-Clamp Profile is pressed into the profile groove then the Shaft is pressed into the Shaft-Clamp Profile. Shafts D10, D14 and D25 must be fixed in position at a chosen location using a dowel DIN 6325, one per length of shaft. ■ ■ For fastening the Shafts for Linear Units to standard profiles ■ ■ Easy to install thanks to clip-in technology L I N E A R S L I D E S