Stavebnicový systém MB 9 - EN

615 4FSWJDF 16 8 8 80 Rack 8 Segment 80 Rack segment, St Spring clip, St, stainless m = 47.0 g 1 set 0.0.621.94 40 8 8 Rack 8 End Section 2 rack end sections, St 2 dowel screws M5x22, St Spring clip, St, stainless m = 50.0 g 1 set 0.0.621.93 Rack 8 Assembly Tool 669 The two parts of the Rack 8 End Section form the start and finish of a rack. As many Segment 80 pieces as required can be used between these two points. The protected clamp technology secures each Segment with no extra work required. The short but precise length of each rack segment eliminates systematic errors typical in longer lengths. The connecting clips form an effective fastening system that holds each rack segment securely in place. Note: Rack 8 must not be installed in profiles of type “light” or “E”. This rack drive is unrivalled in its compact design. There’s nothing above it and no space is wasted. High rigidity and long service life combine with minimum maintenance. 1 ■ ■ The rack sits entirely in the profile groove ■ ■ High drive rigidity with minimum space requirements ■ ■ Practical clamping technology eliminates need for machining during installation 2 3 4 5 6 Safe lifting motion and precise repeatability Rack 8 Rack 8 End Section and Rack 8 Segment 80 M E C H A N I C A L D R I V E E L E M E N T S Rack drive 8 is designed for use with a Linear Slide 8 D14. Precise manufacturing tolerances and an effective and innova- tive longitudinal fastening system result in reduced pitch error over longer lengths.