Kloubová oka Fluro

47 FLURO ® -Gelenklager GmbH 4 1) 7 5,25 14 30 37 6,5 M 4 19 1,7 5,1 14 9 5 8 6,00 18 33 42 7,7 M 5 19 3,5 7,5 600 13 13 6 9 6,75 20 36 46 8,9 M 6 21 5,5 9,3 530 13 20 8 12 9,00 24 42 54 10,4 M 8 25 10,0 16,7 420 14 33 10 14 10,50 28 48 62 12,9 M 10 28 16,0 23,4 350 13 56 12 16 12,00 32 54 70 15,4 M 12 32 20,0 32,0 300 13 87 14 19 13,50 36 60 78 16,8 M 14 38 24,0 42,0 260 16 129 16 21 15,00 42 66 87 19,3 M 16 40 37,0 52,5 230 15 189 18 23 16,50 46 72 95 21,8 M 18x1,5 44 45,5 64,0 210 15 267 20 25 18,00 50 78 103 24,3 M 20x1,5 47 51,5 78,0 190 14 348 22 28 20,00 54 84 111 25,8 M 22x1,5 51 62,0 97,0 170 15 443 25 31 22,00 60 94 124 29,6 M 24x2 57 73,5 122,0 150 15 600 30 37 25,00 70 110 145 34,8 M 30x2 71 97,0 168,0 130 17 1030 35 43 28,00 80 125 165 37,7 M 36x2 73 121,5 206,0 110 19 1600 40 49 35,00 90 142 187 44,2 M 42x2 78 145,0 286,0 100 16 2570 B M A F l o G Gl ! Size (D H7) Rod Ends Series K - Stainless, Maintenance Free Series GARSW..NiRo Rod End with male thread and PTFE liner bonded to the inner surface, completely in AISI 316 For use at high dynamic pressure and tension loads in corrosive environments Materials: Housing: Stainless steel to 1.4404, Aisi 316 insert: Stainless steel 1.4571 with PTFE liner bonded to the inner surface Ball: Stainless steel 1.4404, Aisi316, ground, polished This series is also available sealed (see page 52) or with threaded bolt (see page 53). 1) on request Please note: The dynamic load "C" of the bearing of some rod ends is in some sizes higher than the static load "C o " of the rod end. Static load C o kN Dynamic load C kN limiting speed rev/min Maximum Pivoting Angle (°) only for short-term revolutions recommended Weight g